Maintenance method of diamond saw blade

1. If the diamond saw blade is not used immediately, it should be folded from the saw table and applied with anti-rust oil, and then lay it flat or hang it with the inner hole. Do not stack other objects or footsteps on the flat diamond saw blade. And pay attention to moisture and rust prevention. 　

2. When the diamond saw blade is no longer sharp and the cutting surface is rough, it must be removed from the saw table in time and sent to the diamond saw blade manufacturer for re-grinding (the Kyushu Creative saw blade can be re-grinded 2-8 times, the most Long service life up to 4000 hours or more). Diamond saw blades are high-speed cutting tools, which have high requirements for dynamic balance. Please do not give diamond saw blades to non-professional manufacturers for grinding. Grinding cannot change the original angle and destroy the dynamic balance.

3. The inner diameter correction and positioning hole processing of the diamond saw blade must be handed over to the original manufacturer. If the processing is improper, it will seriously affect the service life and use effect of the diamond saw blade, and may cause the danger of personal and property damage. In principle, the hole reaming should not exceed the original diameter of 20mm, so as not to affect the balance of stress.